 | | Spread Spectrum
|
| <bold>Fred Cass,FCass@nextwavet...m,Internet writes: </bold><x-quoted>I would also be interested in hearing if there are any inexpensive (<<$500), easy to implement wireless comm solutions. Perhaps spreadspectrum 900mhz, or RF...</x-quoted> By (...) (30 years ago, 8-May-97, to lugnet.robotics.handyboard)
| | |  | | RE: (no subject)
|
| (...) If anyone can find Proxim RXA-1000 radios (900 Mhz, Direct Sequence Spread Spectrum), I wrote code for a Handyboard to program the synthesizer. You have to program two registers serially, and then must program one of those registers each time (...) (30 years ago, 8-May-97, to lugnet.robotics.handyboard)
| | |  | | RF transmitters
|
| (...) We did use 900 Mhz Radio Shack RF headphones (cat # 33-1145), which gave us a reasonable analog transmission (the transmitter took L+R RCA audio in, and the we connected in place of the speaker on the receiver). We could get 9600 baud through (...) (30 years ago, 8-May-97, to lugnet.robotics.handyboard)
| | |  | | Re: RF transmitters
|
| (...) A simple way to get rid of the DC component is to run the data through a scrambler on the TX side, and descrambler on the RX side. This has been done successfully in 9600 baud amateur radio TNC's. 2 or 3 chips on each end of the link is all it (...) (30 years ago, 8-May-97, to lugnet.robotics.handyboard)
| | |  | | Re: Accessing 2nd line of display
|
| I *think* rather than /n if you type /m it should be in the second line....I don't remember which letter it is, nor do I have the robotics books near me. Or you can have however many spaces as there are (10? 15?) cursor blanks and leave off the \n (...) (30 years ago, 8-May-97, to lugnet.robotics.handyboard)
| |