To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1556 (+5)
  Re: IR Collision avoidance
 
(...) Those are the IR LED's - the one's that transmit the IR light that the receiver sees. Also, while I'm at it, I found out that the diagram above isn't completely accurate (I drew it from memory). The circuit I really use is like this: (...) (30 years ago, 28-Feb-97, to lugnet.robotics.handyboard)
 
  Re: IR Collision avoidance
 
Hmmm. What voltage and/or LEDs are you using? Assuming 5V, your LEDs age passing only around half a milliamp of current. I am using a 100ma LED and I can only get less than a foot of detection. Am I missing something here? Jun Nolasco (...) (30 years ago, 1-Mar-97, to lugnet.robotics.handyboard)
 
  motor voltages
 
Hi, This is in response to the question about motor voltages posted earlier tonight. Check out the archives. Late last week I posted a similar question and got some good responses about wiring the HB for two power supplies and using diodes. I have (...) (30 years ago, 1-Mar-97, to lugnet.robotics.handyboard)
 
  Re: Reducing Battery Pack Voltage
 
as has been discussed on this list, the Handy Board wasn't really designed for three volt toy motors. Reducing the voltage and doubling the motor chips is a reasonable approach, however. The Handy Board requires 7.2 volts to operate, because of the (...) (30 years ago, 1-Mar-97, to lugnet.robotics.handyboard)
 
  Re: Reducing Battery Pack Voltage
 
U can use an external battery with the HB. It can be 3V. Check the FAQ in the HB HP. The exact link is: (URL) mar Master of Engineering Candidate Project: Mobile Robotics mar@cooper.edu Department of Mechanical Engineering The Cooper Union for the (...) (30 years ago, 1-Mar-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR