 | | Re: RF Module
|
|
Hi. Have you tried attaching the data out (middle pin on three pin header) from the encoder board to the data in (also middle pin on three pin header) on the decoder with a common ground to each? This will allow you to test the encoder/decoder (...) (27 years ago, 9-Sep-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: LMD18200
|
|
(...) Correct, it has a minimum voltage for correct operation. You can use a separate battery pack with a higher voltage and simply connect the grounds to your 9.6V battery. This chip is NOT a 293 replacement. You would have to build a small circuit (...) (27 years ago, 9-Sep-99, to lugnet.robotics.handyboard)
|
| |
 | | hb
|
|
Hi all!! Have someone the eagle files *.sch and *.brd for the hb? Thanks markus (27 years ago, 9-Sep-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: show-me training
|
|
I know that the RCX is the state of the art LEGO computer, but I happen to have a CyberMaster and I noticed all you have said about the Show-me Training (R) applies perfectly to the CyberMaster and much better than the RCX since no extra inputs need (...) (27 years ago, 9-Sep-99, to lugnet.robotics)
|
| |
 | | Re: Sound
|
|
(...) I'm not sure this will help nor if anyone else said anything. I haven't had time to read through everything. So I apologize for redunancy. From the Pitsco/Dacta catalog there is something called a "Sound Element". It's this little round piece (...) (27 years ago, 9-Sep-99, to lugnet.robotics)
|
| |
 | | Re: Kego Constructopedia
|
|
We can use "Kego"! The words of Mike Plusch, the author of "Kego: A Constructopedia for LEGO" (URL): (...) (27 years ago, 9-Sep-99, to lugnet.robotics)
|
| |
 | | LMD18200
|
|
is anyone familiar with this driver chip National Semi LMD18200 H BRIDGE up to 3A continuous 6A peak(200ns) supply voltage from 12-55V QUESTION does this mean i can't use a 9.6V battery pack for motors? is this a plug and play? (27 years ago, 9-Sep-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: O'Reilly book news
|
|
(...) - Legal Entanglements Go On (...) jack j-perdue@tamu.edu (27 years ago, 9-Sep-99, to lugnet.robotics)
|
| |
 | | Re: RcxCC downloads
|
|
I wrote first something like "It seems that this NQC newsgroup is not very active, but that's probably because NQC is 99.999% bug free and so is RCXCC...". So i was definitely not asking more traffic or so, simply looking at what has already been (...) (27 years ago, 9-Sep-99, to lugnet.robotics.rcx.nqc)
|
| |
 | | Conveting ASM files to ICB
|
|
Hello, I have not been able to successfully convert ASM files to the ICB format to use with Interactive C. As a test I tried to convert servo_a5.icb to servo_a5.asm, this is what I got. The file cannot be loaded into IC. Any suggestions? script (...) (27 years ago, 9-Sep-99, to lugnet.robotics.handyboard)
|