 | | Re: pcode downloading
|
|
(...) : (...) I get -8.9v when its not jumped. When jumped I get some floating values in the mV range. I checked all of the solder joints. Changed power supplies. Removed and reseated the chip. Checked power and continuity at various points around (...) (30 years ago, 3-Jan-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: pcode downloading
|
|
(...) OK, well I think it is isolated at the pseudo-MAX232 chip. Did you get the +10 v power supply pin on the p-MAX ok? It's at pin 2. Measure it w/r/t ground and you should get +10v. Before you order a real Maxim, check the polarity of your (...) (30 years ago, 3-Jan-97, to lugnet.robotics.handyboard)
|
| |
 | | Config 0C / 0D
|
|
Hi, I know this is an old chestnut but believe me I have searched the mail archive and nothing quite matches what I'm seeing. I have a handyboard which I made and which seems to work perfectly. However, I have to download (using hbdl) with the (...) (30 years ago, 3-Jan-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Coparison of Sensors
|
|
(...) Looks like you got too many semi-colons. Take out the semi-colons on all the while lines where you want the while to do the following thing. The process is getting to the "while(!start_button());" line and staying there. Also you have too many (...) (30 years ago, 3-Jan-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Coparison of Sensors
|
|
(...) I agree. You should only have a semi-colon after a while if you dont want that while to loop through any instructions. A semi-colon after a while tells the compiler that all you want to do is continuously test the while condition until it (...) (30 years ago, 3-Jan-97, to lugnet.robotics.handyboard)
|