 | | Re: Novice group
|
|
Thomas Main wrote: <novice group?> (...) yes. Here's a new group I can support. (...) It takes a lot of torque to get this puppy to flip, applied sharply. Try fresh batteries, and changing to a high adhesion floor surface. Mine flips all the time (...) (28 years ago, 15-Apr-99, to lugnet.admin.general, lugnet.robotics)
|
| |
 | | OT help needed
|
|
I'm going away for ten days and I have lost the address to sign of this list. Would someone please send instructions to me directly? Thanks in advance, Bob Bailey (28 years ago, 15-Apr-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: AW: Lego Bots in Germany??? (A)
|
|
(...) If you type your CC number with spaces, the system doesn't give you any warning message but does not accept your transaction. I had the same problem, wrote an e-mail and was given this explanation. I suggested to them some more interaction in (...) (28 years ago, 15-Apr-99, to lugnet.robotics)
|
| |
 | | Fwd: Novice group
|
|
(...) <snip> IMHO, this mailing list has slowed down to the point that any traffic (save stupidity) would be welcome. I think there are plenty of lurkers, such as myself, who could benefit from the discussion of basic building techniques as much as (...) (28 years ago, 15-Apr-99, to lugnet.robotics)
|
| |
 | | Temperature sensor limits?
|
|
Does anybody know what the measurement limits are for the temperature sensor (particularly on the high end)? Do you think the sensor could be damaged by exceeding the upper limit? How about plain LEGO pieces -- does anybody know how hot you can get (...) (28 years ago, 15-Apr-99, to lugnet.robotics)
|
| |
 | | RE: Temperature sensor limits?
|
|
# From: tja@cpu.com # Sent: Thursday, April 15, 1999 04:58 PM # To: lego-robotics@crynwr.com # Subject: Temperature sensor limits? # ---...--- # Does anybody know what the measurement limits are for the temperature # sensor (particularly on the high (...) (28 years ago, 15-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Novice group
|
|
This one sounds like a good idea to me. Steve (...) (28 years ago, 15-Apr-99, to lugnet.admin.general, lugnet.robotics)
|
| |
 | | Re: Novice group
|
|
With the current amount of traffic going by these days, I'd say this is not necessary. Besides, it's refreshing to answer some basic questions once in a while. :-) I suspect the traffic will peak again in September to December, when LEGO introduces (...) (28 years ago, 15-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Temperature sensor limits?
|
|
(...) (Bitter) Experience tells me that at about 80 degrees Celsius*) the Lego plastic starts to get noticeably softer. At 90 to 100 degrees Celsius it will start to deform slowly without pressure. At this temperature most Lego will sustain (...) (28 years ago, 15-Apr-99, to lugnet.robotics)
|
| |
 | | RE: SENSOR_READ doesn't return 0
|
|
(...) OOPS, that SHOULD read 0x0080 since the mode is a BYTE value. Overzealous urge to get content into the website is to blame. For the light sensor, I generally use the percent of scale mode. My website has a page on tricks with the light sensor (...) (28 years ago, 15-Apr-99, to lugnet.robotics.rcx.pbforth)
|