To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *10651 (+5)
  RE: rpm of the Geared motor
 
# From: ldsmith@pfc.forestry.ca # Sent: 09 April 1999 07:44 # To: lego-robotics@crynwr.com # Subject: rpm of the Geared motor # ---...--- # Anyone know the rpm of the Geared motor. # If you mean the one that comes with the RIS, it's 350. When I (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  Re: loading s/w
 
(...) legOS has a software solution built-in - when you are ready to quit, hold down the on/off button and press the 'prog' button. Hope this helps! Cheers, Richard (28 years ago, 9-Apr-99, to lugnet.robotics.rcx.legos)
 
  Re: rpm of the Geared motor
 
(...) About 360 rpm, according to my measurements. The non-geared motor runs at about 4200 rpm. (...) Regards, Johannes. (28 years ago, 9-Apr-99, to lugnet.build, lugnet.robotics)
 
  Re: Even more remote controls
 
(...) Since you can control the IR LED directly you should be able to get this all working in SW. You will need to modulate the IR with a 40Khz carrier. From there you then turn on and off the carrier to create the start, data and stop bits. This is (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
 
  Re: Increasing current output to motors on HandyBoard
 
I wonder if this would last since a relay is mechanical and I would assume that it would wear with all that "switching". Doe anyone have any experience with this? Thanks. ---...--- ericson mar Robotics Consultant mar@cooper.edu (212)353-4356 (...) (28 years ago, 9-Apr-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR