To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1041 (+5)
  lead acid battery
 
I would like to replace the battery used on my handyboard with a 12V Lead Acid Battery, either 1.3 ah or 2.2ah. Would I need to make any modifications to the power regulator or charging circuity for this to work? Since the HB charges at 50 mah, I (...) (30 years ago, 2-Dec-96, to lugnet.robotics.handyboard)
 
  Low voltage at digital ports 7 & 8
 
I have been using the Handyboard on an R/C vehicle platform with Hall Effect sensors as the wheel shaft encoders. I've succesfully used the encoders.c routine which requires hooking the Hall Effects to Digital Ports 7&8 for about six months now. The (...) (30 years ago, 2-Dec-96, to lugnet.robotics.handyboard)
 
  Black + White Camera
 
I would like to add a B+W Camera to my robot, and send the signal over a wireless RF connection. I understand the RF part is fairly easy, with a number of solutions, including the commercially available 'Rabbit' doing a fine job. However, I have no (...) (30 years ago, 3-Dec-96, to lugnet.robotics.handyboard)
 
  Re: Black + White Camera
 
Sean, Where can I find out more about this "Rabbit"? Jun Nolasco (...) (30 years ago, 3-Dec-96, to lugnet.robotics.handyboard)
 
  Re: Black + White Camera
 
(...) I put one on my project. Expect video dropouts from Rabbit type (i.e. 900 MHz) devices, when the robot goes behind trees, dense walls, and other areas. If you're using the video to drive the robot remotely, you'll have to back out of such (...) (30 years ago, 3-Dec-96, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR