Subject:
|
how to remove center of 2x2 brick?
|
Newsgroups:
|
lugnet.parts.mod
|
Date:
|
Wed, 25 Aug 2004 17:42:04 GMT
|
Viewed:
|
4740 times
|
| |
|
|
I tried my very first part mod today -- my objective was to drill a clean hole
in the side of a 2x2 brick, and then remove the center cylinder from the inside
of the brick so I have room to stuff some things therein.
The hole in the side of the brick was no problem, but my attempt to drill out
the center cylinder with a 0.25" drill bit was a disaster. The cylinder wall
thinned out a bit, and then ruptured, leaving a big almost-cylinder still there
which now resists all attempts at drilling. (What's worse, when it ruptured my
drill slipped down and poked a hole in the top of the brick, so this one is
ruined -- but I fully expected to ruin a few anyway.)
So. What would you experienced modders suggest for getting rid of that brick
center? I don't need to remove it all the way flush with the roof of the brick;
I just need to get rid of enough of it to have some working room inside.
Thanks,
- Joe
|
|
Message has 1 Reply:
 | | Re: how to remove center of 2x2 brick?
|
| "Joe Strout" <joe@strout.net> wrote in message news:I30Ju4.1MIp@lugnet.com... (...) Honestly, what I do is a little brute force , but it works nicely. Take a small pair of needle nose pliers and grip the cylinder in such a manner that one jaw of (...) (20 years ago, 25-Aug-04, to lugnet.parts.mod)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
