 | | Re: Which glue?
|
|
(...) I still swear by Goop. But I have to ask what the hec is this for? (URL) (17 years ago, 22-Feb-08, to lugnet.parts.mod)
|
| |
| | Re: How do -you- clean your LEGO parts?
|
|
(...) I use washing machine. I pre-sort the parts, plates longer than 8 go out, anything printed/glass/sticke...d/electric goes out, and also the things from softer plastic should go (trees, clips etc.). Then I put it in cloth bag (old pillow), (...) (17 years ago, 21-Feb-08, to lugnet.parts)
|
| |
| | Re: How do -you- clean your LEGO parts?
|
|
(...) Tooth brush is what I use to be very careful, and an old electric tooth brush. For large amounts I use the dish washer on delicate, cold water, bricks in a girly stuff bag, no drying. I take them out and put them under a fan after laying them (...) (17 years ago, 21-Feb-08, to lugnet.parts)
|
| |
| | Re: Which glue?
|
|
(...) Brian, I would try a dab of silicone adhesive caulk. You can check the specs but think would be good down to -60----if not there are some that are. Messy but would bet it would work. Also, try roughing up the beam with bit of sandpaper which (...) (17 years ago, 21-Feb-08, to lugnet.parts.mod)
|
| |
| | How do -you- clean your LEGO parts?
|
|
I don't think LUGNET has had any discussions about this in quite some time. How do -you- clean your LEGO parts? I'm interested in learning people's techniques, particularly ones that clean a lot of parts at once with little effort. LEGO that's been (...) (17 years ago, 21-Feb-08, to lugnet.general, lugnet.parts)
|
| |
| | Re: Which glue?
|
|
(...) Brian, Have you tried Gorilla Glue? You just have to be careful not to use too much as it expands as it dries. I'm also assuming that it's the flat-plain side(s) of the beam (not the technic pin hole side(s) ) that you are trying to affix to (...) (17 years ago, 21-Feb-08, to lugnet.parts.mod)
|
| |
| | Re: Which glue?
|
|
(...) OK, to revive this thread, I've had zero luck gluing ABS studless beams to the backside of mirrors - superglue doesn't seem to stick at all. Any ideas? What am I doing wrong, etc.? 2 component epoxy isn't likely to work either, given the (...) (17 years ago, 21-Feb-08, to lugnet.parts.mod)
|
| |
| | Re: Can't find this part on Peeron: 2x2 plates with connecting stem
|
|
(...) That's more or less correct. If you pull up an individual part entry, the far right column shows what sets it's been used in (if it's a part, minifig, or some other sub-component of a set), and the next column to the left will give you rolling (...) (17 years ago, 30-Jan-08, to lugnet.parts)
|
| |
| | Re: Can't find this part on Peeron: 2x2 plates with connecting stem
|
|
(...) Lugnet has a tab somewhere in the catalog section that gives the high and low and average price or medium price. It is very handy as I think that it keeps track of what was sold and does not reset once there are none on Bricklink John P (17 years ago, 29-Jan-08, to lugnet.parts)
|
| |
| | Re: Can't find this part on Peeron: 2x2 plates with connecting stem
|
|
(...) That is the inherent difficulty when selling such parts, there is no sound way to determine up ahead what a person would be willing to pay for it. Since I'm not in demant for it either, my "gut feeling" estimate for the price would be a low (...) (17 years ago, 29-Jan-08, to lugnet.parts)
|
| |
| | New Power Functions Electronics Folder
|
|
The new Power Functions Electronics folder in my Brickshelf: (URL) contains circuits and pictures of how to use electronics with your PF parts. So far there are PF lead mods, a light direction, latch and flash circuit, which can keep train lights on (...) (17 years ago, 29-Jan-08, to lugnet.technic, lugnet.trains, lugnet.general, lugnet.robotics, lugnet.loc.uk, lugnet.parts.mod)
|
| |
| | Re: Can't find this part on Peeron: 2x2 plates with connecting stem
|
|
(...) Ah, many thanks, Manfred! Another question for you if you don't mind. Since no one is selling this part on Bricklink, what would you ask for it? A dollar? Five dollars? I was thinking a dollar since it is an old and rare part, yet I've never (...) (17 years ago, 27-Jan-08, to lugnet.parts)
|
| |
| | Re: Can't find this part on Peeron: 2x2 plates with connecting stem
|
|
(...) Hello David, It's part number 650 - Hinge Coupling-Nylon (URL) friendly greetings, M. Moolhuysen. (17 years ago, 26-Jan-08, to lugnet.parts)
|
| |
| | Can't find this part on Peeron: 2x2 plates with connecting stem
|
|
Y'all know the part I mean: two white-translucent 2x2 plates with smooth bottoms connected by a very thin strand (space of 3 studs between the two plates). I believe they were used as truck or car hitches. Searched for "2 x 7" parts and found (...) (17 years ago, 26-Jan-08, to lugnet.parts)
|
| |
| | Is there a sticker database anywhere
|
|
Is there a site or database out there listing parts with stickers on them and which sets they came in? Something I can use if I have a stickered part and want to find out what set(s) it cames in or if I want to know what parts the stickers for a (...) (17 years ago, 25-Jan-08, to lugnet.parts, lugnet.general)
|
| |
| | Re: part/color combos you wish existed
|
|
(...) I would love to see technic triangles in lime and orange. (URL) would also like technic cams in yellow, lime, orange, red, and green. (URL) (17 years ago, 12-Dec-07, to lugnet.parts)
|
| |
| | part/color combos you wish existed
|
|
What parts do you wish existed in colors they dont currently exist in? My votes for parts I would love to see: Wing 2 x 4 (URL) in black (great for the front hood of cars and such) Windscreen 3 x 4 x 1 & 1/3 Slope 33 (URL) in trans-smoke More (...) (17 years ago, 11-Dec-07, to lugnet.parts)
|
| |
| | Re: Another new element? (was Thomas Update with new element!)
|
|
(...) And if you look at the new Indiana Jones motorcycle chase you'll see a 1x4x3 version similar to this. Looks like a new window system. Tim (17 years ago, 4-Dec-07, to lugnet.trains, lugnet.parts, FTX)
|
| |
| | Re: Another new element? (was Thomas Update with new element!)
|
|
(...) Yea, this is the new 1x2x2 windows with clipping glass (imagine a trans black or trans light blue glass instead!!!). I've got this informations from somebody on 1000steine forum. Moreover note the new door fitting the 1x4x6 frame... not bad! (...) (17 years ago, 4-Dec-07, to lugnet.trains, lugnet.parts, FTX)
|
| |
| | Another new element? (was Thomas Update with new element!)
|
|
(...) Another question about a new element. Take a look at this picture here (2008 Creator house set): (URL) See the white 1x2x2 windows on the second level of the house? Could these be an updated version of our beloved 1x2x2 old-style windows that (...) (17 years ago, 4-Dec-07, to lugnet.trains, lugnet.parts, FTX)
|
