 | | Re: Reed sensors are not working very well (or too well?) —Dean Husby
|
| | | (...) I had the sensor in the center of the track on the bottom. Didn't work too well. I've since asked that it be moved to the side where it can be triggered via the side. I'll be doing testing today on that. Dean (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc, lugnet.trains)
|
| | | |
| | | | | Re: Reed sensors are not working very well (or too well?) —Robin Sather
|
| | | | (...) Dean, I've put a magnet mounted in the middle of the first car (not the engine or tender). It's vertically just above the wheel hubs halfway between the bottom of the car and the top of the track. The face of the magnet sticks out ever so (...) (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc, lugnet.trains)
|
| | | | |
| | | | | | Re: Reed sensors are not working very well (or too well?) —Dean Husby
|
| | | | | (...) Our widest trains are 8 studs wide right? So that puts it to the end of the track. I'll make a little building with the switch recessed. How high is it from the table to where the center of the switch is? I'll need this to setup the height's. (...) (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc)
|
| | | | | |
| | | | | | Re: Reed sensors are not working very well (or too well?) —Dean Husby
|
| | | | (...) Robin, I've created a building hiding the sensor. (URL) here is the side showing the sensor. (URL) it's height, is this good for you? My program will be created on this building being 1 stud away away from the track base. This gives 10 stud (...) (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc, lugnet.trains)
|
| | | | |
| | | | | | Re: Reed sensors are not working very well (or too well?) —Robin Sather
|
| | | | (...) The train car will still have no problems clearing as long as my "inside-1" (1 fulll stud clearance beyond the end of railroad tie on inside corners). On a straight, it doesn't even come to the end of the tie. I'm not sure where you're placing (...) (23 years ago, 26-Jul-01, to lugnet.org.ca.vlc, lugnet.trains)
|
| | | | |
| | | | | | Re: Reed sensors are not working very well (or too well?) —Dean Husby
|
| | | | (...) Good. (...) Sounds good. I've finished the Hogwarts program. I've also added another sensor that can detect when the track is busy and delay the hogwarts from leaving. This will allow us to run two Passenger trains safely! It's going to be (...) (23 years ago, 27-Jul-01, to lugnet.org.ca.vlc, lugnet.trains)
|
| | | | |
