To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.org.ca.rtltorontoOpen lugnet.org.ca.rtltoronto in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Organizations / Canada / rtlToronto / 8761
  Re: rtlToronto15 January issues
 
(...) Hey, INS was getting possessive, and didn't want to let me leave the country. Now that that's fixed, maybe we'll visit for the next event :) (...) Maybe I'm dense. Actually, forget the maybe - but here's what I'm thinking of (bad ascii art (...) (21 years ago, 25-Aug-03, to lugnet.org.ca.rtltoronto)
 
  Re: rtlToronto15 January issues
 
(...) I blame the ascii art. :) this is the problem I see. (more ascii art) 1 2 ---...--- I red I I I 3 OK, put a robot at the base of the T. (number 3) as it drives up the pipe, it reads the RED tape. so it should turn left to the # 2. so far easy. (...) (21 years ago, 25-Aug-03, to lugnet.org.ca.rtltoronto)
 
  Re: rtlToronto15 January issues
 
(...) I like it. The original thought was that before each joint there would be 1 strip or 2 1 strip means 'go left' (as left as left can be in a 3 d grid), or 2 stripes means go right (again, same). As pointed out, however, which way's left or (...) (21 years ago, 25-Aug-03, to lugnet.org.ca.rtltoronto)
 
  Re: rtlToronto15 January issues
 
(...) Oh, that's easy - just use a four-bit BCD TapeCode, assigning a 3-digit rotational position about theta to find the correct pipe exit point. Piece of cake. In addition to playing "What a Girl Wants", all robots must bake a cake, and hop on one (...) (21 years ago, 25-Aug-03, to lugnet.org.ca.rtltoronto)
 
  Re: rtlToronto15 January issues
 
(...) Ah ha! Here's where we differ - I don't see the problem :P You read the markers are you approach the T joint, and expect to know which way to go with the knowledge aquired. My markers are _after_ the T, and they just tell you if you're going (...) (21 years ago, 25-Aug-03, to lugnet.org.ca.rtltoronto)
 
  Re: rtlToronto15 January issues
 
(...) Okay, what about this: 1---...---T------2 ^^^| | | | 3 Entering joint at 1, white tape is ONLY on the half of the pipe which has the correct path 3. We tape around 180 degrees of the pipe (ie, a C shape). This also allows the robot to align (...) (21 years ago, 25-Aug-03, to lugnet.org.ca.rtltoronto)
 
  Re: rtlToronto15 January issues
 
(...) Look, we've been over this before, no non Lego parts, especially not the HiTechnic Christina Aguilera module. Sheesh. Calum PS-if we tape it pre T and single true path, I think it's hard, but not excurciatingly hard. Basically it's time for a (...) (21 years ago, 25-Aug-03, to lugnet.org.ca.rtltoronto)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR