 | | Re: Is it wrong to cut up flex tubing?
|
|
(...) I'm not sure what was meant by saying flex tubing was used in design of the trucks discused in that thread. I did up a diagram of my truck, but I can't post it at the moment. Hopefully later tonight or tomorrow. Basicly you pop the wheels out (...) (22 years ago, 17-Sep-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Is it wrong to cut up flex tubing?
|
|
(...) Ok so I finish the base of the truck. (URL) is the older design. I still need to find the model for the 2 long half beam so I can model the new design. Derek (22 years ago, 17-Sep-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Is it wrong to cut up flex tubing?
|
|
"Derek Raycraft" <derek.raycraft@sitraka.com> wrote in message news:3D87C15D.803080...aka.com... (...) You guys are so good at this! Iain (22 years ago, 18-Sep-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Is it wrong to cut up flex tubing?
|
|
Sorry to jump into the thread late and dumb, but *doh*... Looking at the rendering... you've captured a flex tube between two of those motor-mounting 2x1 plates with the extra bit on them? And that's your axle for the train? I think that's one of (...) (22 years ago, 19-Sep-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Is it wrong to cut up flex tubing?
|
|
(...) I think you've go it a little mixed up. The wheels in my truck are taken from the 9V train wheel block. (URL) are surprisingly easy to pop out. Never thought of doing this before though. The metal axle that holds the two wheels together is the (...) (22 years ago, 19-Sep-02, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: Is it wrong to cut up flex tubing?
|
|
"Jeff Elliott" <jeffe@telepres.com> wrote in message news:3D89E534.6FE52B...res.com... (...) There isn't any flex tubing in Derek's *axles*, he's got it between the crosses in the 2x1x0.5 beams that are shown as 3x1x0.5 beams. But what I don't get (...) (22 years ago, 19-Sep-02, to lugnet.org.ca.rtltoronto)
|
