 | | Re: rtl21 B —Chris Magno
|
| | | (...) If I know Dave, he will start now, and build a 14lb bot, then have to spend the entire brickfest re-making it. Besides, Steve, now that everyone will be using the inside out tyre(Tm)(Pat Pending) (C) (1) idea that I came up with, how much fun (...) (18 years ago, 2-Aug-06, to lugnet.org.ca.rtltoronto)
|
| | | |
| | | | | Re: rtl21 B —Steve Hassenplug
|
| | | | (...) I know. Those look like they'd work much better than anything else I've seen. There must have been some other design flaw that caused you to lose so bad. Steve (18 years ago, 2-Aug-06, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: rtl21 B —Chris Magno
|
| | | | (...) Seriously, I think the tires were too sticky. When the bot met with something "immovable" (like an anchor bot) then the bot would STOP. I really dont recall, but I think, none of my loss's were do to actually being PULLED. (I expect to be (...) (18 years ago, 3-Aug-06, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: rtl21 B —Rob Antonishen
|
| | | | (...) Then you should have geared them down more. If it was possible to stall the motors, and the tires weren't slipping then your speed would have been reduced more, increasing your torque until you got to a point just before they would slip. -Rob (...) (18 years ago, 3-Aug-06, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: rtl21 B —Chris Magno
|
| | | | | (...) hummm, i dont think i follow this logic. I wanted the speed to try to get to the end of the table as fast a possiable. I had the torque, with the worm to 24, and it was driven with the slower port of the RC motor. OFF TOPIC!!! (calum dont read (...) (18 years ago, 3-Aug-06, to lugnet.org.ca.rtltoronto)
|
| | | | | |
| | | | | | | Re: rtl21 B —Calum Tsang
|
| | | | | | | (...) Can you do me a favour and not do this until the restaurant clears out towards the end of the night? :) Calum (18 years ago, 3-Aug-06, to lugnet.org.ca.rtltoronto)
|
| | | | | | | |
| | | | | | | Re: rtl21 B —Steve Hassenplug
|
| | | | | | (...) Interesting idea. (18 years ago, 3-Aug-06, to lugnet.org.ca.rtltoronto)
|
| | | | | | |
| | | | | | Re: rtl21 B —Derek Raycraft
|
| | | | (...) Yes but his design relied on speed as well. So what he really needed is a dual drive system that allowed a high torque motor to come into play when the high speed motor was stalled. I built one of these for my king of the hill robot which (...) (18 years ago, 3-Aug-06, to lugnet.org.ca.rtltoronto)
|
| | | | |
