 | | Re: Y??? 'Cause I'm asking!!! —Rob Antonishen
|
| | | (...) mmmm I'd disagree. I think shared walls should be allowable (as I can't think of a good reason why not :) I'd say the XXXXOOOOOOOOXXXXOOOOOOOOXXXX is allowed so long as it is all on one plane. This (two openings) is the maximum that can fit on (...) (19 years ago, 13-Jan-06, to lugnet.org.ca.rtltoronto)
|
| | | |
| | | | | Re: Y??? 'Cause I'm asking!!! —Derek Raycraft
|
| | | | (...) > (...) Ok but this was discussed months ago and it was decided that this would not be allowed. I don't think this issue should be reopened at this stage. (...) The defined transfer "buffer" needs to be one colour, the rest can be what ever (...) (19 years ago, 13-Jan-06, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: Y??? 'Cause I'm asking!!! —Rob Antonishen
|
| | | | (...) I'm OK with that. I just know it never made it into the "official" transfer set description, or the "guidelines", so I didn't know it had been agreed to. -Rob A> (19 years ago, 13-Jan-06, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: Y??? 'Cause I'm asking!!! —Chris Magno
|
| | | | (...) After reviewing the offical draft rules page, this MIGHT cover it, but could be open to interpatation. --snip--- The width of the outside dimension can be as wide as you want, except that it must always preserve the 4 dot margin on each side. (...) (19 years ago, 13-Jan-06, to lugnet.org.ca.rtltoronto)
|
| | | | |
