Subject:
|
Re: A hinging problem
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Tue, 15 Nov 2005 16:08:48 GMT
|
Viewed:
|
939 times
|
| |
|
|
In lugnet.org.ca.rtltoronto, Rob Antonishen rob.antonishen@gmail.com wrote:
| |
On 11/14/05, Calum Tsang wrote:
| |
I forgot about that part completely! On revisiting this issue, I have a
further problem with the space. :( I think it’s even smaller--a 3x1 on the
bottom and a 4x1 on the top. Any ideas?
|
About the only hinge-like thing I can think of that will fit in a 3x1
space, hinged on the long side is the standard 3937 Hinge 1 x 2 Base
and 3938 Hinge 1 x 2 Top combination.
But that is 1 brick high rather than 2 plates high.
-Rob A>
|
how about 2 of these:
with a lightsabre blade (or similar) between them and an appropriate part to
connect the top? (you can tell i’m writing this as I think of it, as well as
butting into the famous rtl...!)
-Matt J
|
|
Message has 2 Replies:
 | | Re: A hinging problem
|
| (...) Good idea Matt - How about something like 48336 (Plate 1 x 2 with Handle Type 2) I don't have any, but they look like they would snap onto a couple of 2555's -Rob A> (19 years ago, 15-Nov-05, to lugnet.org.ca.rtltoronto)
|
Message is in Reply To:
| | Re: A hinging problem
|
| (...) About the only hinge-like thing I can think of that will fit in a 3x1 space, hinged on the long side is the standard 3937 Hinge 1 x 2 Base and 3938 Hinge 1 x 2 Top combination. But that is 1 brick high rather than 2 plates high. -Rob A> (19 years ago, 15-Nov-05, to lugnet.org.ca.rtltoronto)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
