Subject:
|
Re: [rtlToronto] rtlToronto19 Robotics Contest Rules and Date Finalized
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Wed, 7 Sep 2005 03:34:50 GMT
|
Viewed:
|
818 times
|
| |
|
|
Rob Antonishen wrote:
> On 8/26/05, Chris Magno wrote:
>
> > THEN Since the rules state the robot with its "side" up at the end of
> > the game, is the winner, i see no reason why we CANT just put in a STOP
> > screw to prevent the FULL rotation of the board.
>
>
>
> I have completed fabricating both an "Official RTL19 BoP Beam"(tm):
> http://www.brickshelf.com/gallery/ffaat/RTL19/image0.jpg
>
> and an "Official RTL19 BoP Test Harness"(tm):
> http://www.brickshelf.com/gallery/ffaat/RTL19/image1.jpg
> (The sawed off 2 1/2 feet of 2x4 from my upright, cause there is NO
> WAY my SO will let be being the whole "Official RTL19 BoP Beam"(tm)
> into the living room.)
your "workshop" kinda looks like mine
> Two remaining questions -
>
> 1) The "Official RTL19 BoP Rules"(tm) say the bolt head will be
> countersunk, but neither Mr. Magno nor I have done so... Does anyone
> think it matters?
Umm WHAT??? sure it is.
http://peach.mie.utoronto.ca/events/lego/lego-090005/lego-090005-photo3.jpg
it was counter sunk since its creation.
> 2) What is the decision on a "stop screw", and where/how would it be located?
>
> -Rob A>
>
> ....off to continue building madly ....bwahahahaha....
if i said "to be decided" would that upset people?
Chris
|
|
Message has 1 Reply:
Message is in Reply To:
17 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
