Subject:
|
Re: [rtlToronto] rtlToronto19 Robotics Contest Rules and Date Finalized
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Wed, 7 Sep 2005 01:58:35 GMT
|
Reply-To:
|
rob.antonishen@gmail.comSTOPSPAM
|
Viewed:
|
792 times
|
| |
|
|
On 8/26/05, Chris Magno wrote:
>
> THEN Since the rules state the robot with its "side" up at the end of
> the game, is the winner, i see no reason why we CANT just put in a STOP
> screw to prevent the FULL rotation of the board.
I have completed fabricating both an "Official RTL19 BoP Beam"(tm):
http://www.brickshelf.com/gallery/ffaat/RTL19/image0.jpg
and an "Official RTL19 BoP Test Harness"(tm):
http://www.brickshelf.com/gallery/ffaat/RTL19/image1.jpg
(The sawed off 2 1/2 feet of 2x4 from my upright, cause there is NO
WAY my SO will let be being the whole "Official RTL19 BoP Beam"(tm)
into the living room.)
Two remaining questions -
1) The "Official RTL19 BoP Rules"(tm) say the bolt head will be
countersunk, but neither Mr. Magno nor I have done so... Does anyone
think it matters?
2) What is the decision on a "stop screw", and where/how would it be located?
-Rob A>
....off to continue building madly ....bwahahahaha....
|
|
Message has 1 Reply:
Message is in Reply To:
17 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
