Subject:
|
Re: Ponder... If....
|
Newsgroups:
|
lugnet.general
|
Date:
|
Sat, 5 Jun 1999 10:19:29 GMT
|
Viewed:
|
656 times
|
| |
|
|
Once upon a time, (on Fri, 4 Jun 1999 15:18:03 GMT, to be precise!), Mookie
uttered the following profundities....
> This might not belong in this group.. though I'm not sure where else I'd
> put it...
>
> If you could get your hands on any mold lego's made for any part they
> have or currently make... which one would you choose???
> You can only choose one mold...
> I'm still not sure just what one I'd pick....
> I'm thinking it would be the inverted corner slope though...
>
> What would everyone else pick???
>
> Tamy
>
>
2x4 *plate*, as one could use three for a 2x4 brick.
That would provide the most versatility, IMO.
--
_____________________________________________________________
richard.dee@nospam.virgin.net remove nospam.(lugnet excepted)
Web Site: http://freespace.virgin.net/richard.dee/lego.html
ICQ 13177071 AOL Instant Messenger: RJD88888
_____________________________________________________________
For the best Lego news, visit: http://www.lugnet.com/news/
Need instructions for a model? http://www.kl.net/scans/
_____________________________________________________________
|
|
Message is in Reply To:
 | | Ponder... If....
|
| This might not belong in this group.. though I'm not sure where else I'd put it... If you could get your hands on any mold lego's made for any part they have or currently make... which one would you choose??? You can only choose one mold... I'm (...) (25 years ago, 4-Jun-99, to lugnet.general)
|
18 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
