Subject:
|
Re: Brasso again! (Was Re: Quarter-dome UFO Hulls, No Print)
|
Newsgroups:
|
lugnet.general
|
Date:
|
Tue, 18 Jan 2000 14:28:57 GMT
|
Viewed:
|
687 times
|
| |
|
|
In lugnet.general, Jeff Stembel writes:
> In lugnet.general, Scott Edward Sanburn writes:
> >
> > I watched this thread about Brasso, where can you get some, in terms of
> > retailers around the US? (I.E. Walmart, etc.) I want to try it out, I
> > have many "useless" parts that need liberating!
> >
> > Scott S.
>
> Any hardware store should carry it, in the "Polishes" section. My local
> Hardware City (Local Chain, I think) had some for about $3.50. It comes in a
> little metal bottle.
>
> Jeff
Forgot to mention: So far I've cleaned 7 pieces, and it works pretty well. If
you look closely, you can see the imprint of the printing, but more rubbing may
be able to remove that. Use a soft cloth (an old t-shirt works), and do
something else(like watch TV) while doing it. I took me about 5-10 minutes
each for a 1x4 brick, a McD's Slope, and the pice from 5823. The Drawers from
5823 and one of the Trans-Green Hinged Panels from 6180 took a little longer.
The other piece, a 3x2 slope took over an hour(1)! And it still needs a little
more work! It is nice and smooth though. :)
Jeff
1 - I may be doing something wrong, though.
|
|
Message has 1 Reply:
Message is in Reply To:
11 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
