 | | Re: Hardest Piece to remove? —Jeremy Sproat
|
| | | (...) Nope. Take a space antenna piece, and send it pointy-end-down through a hole in a Technic plate, and push them together. The studs on the plate hold onto the antenna base pretty well on their own, and the stud on the antenna is firmly wedged (...) (25 years ago, 30-Nov-99, to lugnet.general)
|
| | | |
| | | | | Re: Hardest Piece to remove? —Adrian Drake
|
| | | | (...) Nah, that's an easy one. Just take a stack of technic beams about 2 plates less than the length of the space antenna. Place the technic plate onto the beams, with the antenna going through the holes. Hold the whole mess together tightly and (...) (25 years ago, 30-Nov-99, to lugnet.general)
|
| | | | |
| | | | | | Re: Hardest Piece to remove? —Mark Koesel
|
| | | | | If I'm not mistaken, I believe there are two parts you can put together that are _impossible_ to remove without destroying one of both of them. Don't try this at home :) Get one of the octagonal Aquazone 'duct' pieces that has an angle at one end. (...) (25 years ago, 30-Nov-99, to lugnet.general)
|
| | | | | |
| | | | | | Re: Hardest Piece to remove? —Tobias Möller
|
| | | | Or, the antenna will get bent. I tried something like this when separating a tyre from a wheel. I out an antenna in the wheel center, whacked it on a table, and the antenna went right through the wheel! --Tobias (...) the (...) together (...) block (...) (25 years ago, 16-Jan-00, to lugnet.general)
|
| | | | |
