|
|
 | | Re: L3PLiTE?
|
| Leonardo Zide wrote... (...) I assume you have manually added extra info to all parts into your pieces.bin. Is there any chance you could export that info into some META commands to be inserted into each part in the LDraw PARTS base, so LDraw (...) (25 years ago, 29-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
| | | | | Re: L3PLiTE?
|
| (...) It does take some extra time to load a big file but the speed increase later is well worth it. After doing the initial calculations, you only need to check the studs for the bricks you move so it's very fast. Leonardo (25 years ago, 29-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
| | | | | Re: L3PLiTE?
|
| Leonardo: (...) So in "every" part you have put a "stud-slot-point" in all the places where a stud from another part can connect with this part. So if a stud on a non-transparent part is at the stud-slot of another non-transparent part, it is (...) (25 years ago, 29-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
| | | | | Re: L3PLiTE?
|
| (...) Basically it checks if a stud primitive is close to a "inverted stud" (the cylinders under a plate for example) or to some predefined points added by me and remove them. The original idea was to make the bricks really connect when they get (...) (25 years ago, 28-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
| | | | | Re: L3PLiTE?
|
| Leonardo Zide <leonardo@centroin.com.br> wrote in message news:38DFDCB4.594866....com.br... (...) So what test do you run to determine what studs get removed? -John Van (25 years ago, 28-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
|
|
