Subject:
|
Re: Sugestions and Requests.
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Mon, 11 Dec 2000 04:48:28 GMT
|
Viewed:
|
2743 times
|
| |
|
|
In lugnet.cad.mlcad, Will Hess writes:
Michael says. Perhaps you are using an older version of MLCad?
>
> I believe Gary wants a list of parts that is NOT sorted by step number. For
> now, the best way to do this is to save a second copy of the model, remove all
> steps and then print a parts list.
>
> Will
Thats it!
like a set inventory,showing how many of each piece is in the whole model
instead of in each step.
(I have no idea why it wasn't that easy to explain in the first place!)
THanks!
Gary
|
|
Message has 2 Replies:
 | | Re: Sugestions and Requests.
|
| In the report dialog there is a checkbox to enable the parts-per-step report. If this is not checked you will receive a report over the complete model. I'll check that in the file-report as well - (I'm not sure here) Is it ok, that MLCad takes care (...) (24 years ago, 11-Dec-00, to lugnet.cad.mlcad)
| | | Re: Sugestions and Requests.
|
| (...) Oh, I see Gary. Sorry, I don't usually put steps in models that I build, because they are usually only for my own use. That's why I didn't see the problem that you were having when I looked at my own model. Sorry about the confusion. -Andy (...) (24 years ago, 11-Dec-00, to lugnet.cad.mlcad)
|
Message is in Reply To:
| | Re: Sugestions and Requests.
|
| (...) I believe Gary wants a list of parts that is NOT sorted by step number. For now, the best way to do this is to save a second copy of the model, remove all steps and then print a parts list. Will (24 years ago, 10-Dec-00, to lugnet.cad.mlcad)
|
11 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
