Subject:
|
Re: Help! - MLCAD won't read 754.dat
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Fri, 17 Mar 2000 16:55:38 GMT
|
Viewed:
|
6681 times
|
| |
|
|
In lugnet.cad.mlcad, John VanZwieten wrote:
> Steve Bliss <blisses@worldnet.att.net> wrote in message
> news:s1m5bs49sah2vvq2ogghtvkfnf675cc57j@4ax.com...
> > In lugnet.cad.mlcad, Michael Lachmann wrote:
> >
> > > The problem is in the dat file itself, due to another problem in MLCad it • is
> > > reported as if it would not exist.
> > >
> > > The file 754.dat contains some illegal character-combinations in the lines
> > > 29 and 30. Both start with "01" instead of "0" or "1".
> >
> > Thanks for pointing those out. I think those lines should be viewed as
> > *valid*,
> > but not *well-formed*. I'll clean them up, and put the correction in the
> > next
> > parts update.
>
> Those two lines can just be deleted from the file. That's probably what you
> meant by cleaning up, but just to be sure. . .
Okey-day. Consider them deleted.
Steve
|
|
Message is in Reply To:
 | | Re: Help! - MLCAD won't read 754.dat
|
| Steve Bliss <blisses@worldnet.att.net> wrote in message news:s1m5bs49sah2vvq...4ax.com... (...) is (...) *valid*, (...) next (...) Steve, Those two lines can just be deleted from the file. That's probably what you meant by cleaning up, but just to (...) (27 years ago, 16-Mar-00, to lugnet.cad.mlcad)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
