Subject:
|
Re: Help! - MLCAD won't read 754.dat
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Tue, 22 Feb 2000 18:42:29 GMT
|
Viewed:
|
1837 times
|
| |
|
|
In lugnet.cad.mlcad, Michael Lachmann wrote:
> The problem is in the dat file itself, due to another problem in MLCad it is
> reported as if it would not exist.
>
> The file 754.dat contains some illegal character-combinations in the lines
> 29 and 30. Both start with "01" instead of "0" or "1".
Thanks for pointing those out. I think those lines should be viewed as *valid*,
but not *well-formed*. I'll clean them up, and put the correction in the next
parts update.
Steve
|
|
Message has 1 Reply:
 | | Re: Help! - MLCAD won't read 754.dat
|
| Steve Bliss <blisses@worldnet.att.net> wrote in message news:s1m5bs49sah2vvq...4ax.com... (...) is (...) *valid*, (...) next (...) Steve, Those two lines can just be deleted from the file. That's probably what you meant by cleaning up, but just to (...) (25 years ago, 16-Mar-00, to lugnet.cad.mlcad)
|
Message is in Reply To:
| | Re: Help! - MLCAD won't read 754.dat
|
| The problem is in the dat file itself, due to another problem in MLCad it is reported as if it would not exist. The file 754.dat contains some illegal character-combinations in the lines 29 and 30. Both start with "01" instead of "0" or "1". The (...) (25 years ago, 21-Feb-00, to lugnet.cad.mlcad)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
