Subject:
|
Re: Help! - MLCAD won't read 754.dat
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Thu, 16 Mar 2000 20:16:55 GMT
|
Viewed:
|
2507 times
|
| |
|
|
Steve Bliss <blisses@worldnet.att.net> wrote in message
news:s1m5bs49sah2vvq2ogghtvkfnf675cc57j@4ax.com...
> In lugnet.cad.mlcad, Michael Lachmann wrote:
>
> > The problem is in the dat file itself, due to another problem in MLCad it • is
> > reported as if it would not exist.
> >
> > The file 754.dat contains some illegal character-combinations in the lines
> > 29 and 30. Both start with "01" instead of "0" or "1".
>
> Thanks for pointing those out. I think those lines should be viewed as • *valid*,
> but not *well-formed*. I'll clean them up, and put the correction in the • next
> parts update.
>
> Steve
Steve,
Those two lines can just be deleted from the file. That's probably what you
meant by cleaning up, but just to be sure. . .
-John Van
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Help! - MLCAD won't read 754.dat
|
| (...) Thanks for pointing those out. I think those lines should be viewed as *valid*, but not *well-formed*. I'll clean them up, and put the correction in the next parts update. Steve (25 years ago, 22-Feb-00, to lugnet.cad.mlcad)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
