 | | Help! - MLCAD won't read 754.dat
|
|
Help! I've tried to load several different models into MLCAD that use the "hose" subparts, and EVERY TIME, MLCAD responds with the message "The file 754.DAT was not found. Continue loading?" for EACH AND EVERY occurrence of 754.dat. I've tried (...) (25 years ago, 17-Feb-00, to lugnet.cad.mlcad)
|
| |
| | Re: Help! - MLCAD won't read 754.dat
|
|
The problem is in the dat file itself, due to another problem in MLCad it is reported as if it would not exist. The file 754.dat contains some illegal character-combinations in the lines 29 and 30. Both start with "01" instead of "0" or "1". The (...) (25 years ago, 21-Feb-00, to lugnet.cad.mlcad)
|
| |
| | Re: Help! - MLCAD won't read 754.dat
|
|
(...) Thanks for pointing those out. I think those lines should be viewed as *valid*, but not *well-formed*. I'll clean them up, and put the correction in the next parts update. Steve (25 years ago, 22-Feb-00, to lugnet.cad.mlcad)
|
| |
| | Re: Help! - MLCAD won't read 754.dat
|
|
Steve Bliss <blisses@worldnet.att.net> wrote in message news:s1m5bs49sah2vvq...4ax.com... (...) is (...) *valid*, (...) next (...) Steve, Those two lines can just be deleted from the file. That's probably what you meant by cleaning up, but just to (...) (25 years ago, 16-Mar-00, to lugnet.cad.mlcad)
|
| |
| | Re: Help! - MLCAD won't read 754.dat
|
|
(...) Okey-day. Consider them deleted. Steve (25 years ago, 17-Mar-00, to lugnet.cad.mlcad)
|
