 | | Re: Part number for baseplate?
|
|
(...) This one? (URL) Heather -- Heather Patey St. John's, Newfoundland, Canada Pirate Wench / Brick Detective (24 years ago, 5-Mar-01, to lugnet.cad.dev)
|
| |
| | Part number for baseplate?
|
|
I haven't seen one in years, but I recall that the Homemaker sets included a mid-size blue baseplate with studs along the perimeter and a textured but non-studded central area. Does anyone know the part number for this? Does it exist in LCad? Dave! (24 years ago, 5-Mar-01, to lugnet.cad.dev)
|
| |
| | Re: Part numbers master list ?
|
|
(...) There is no defacto set, because the Pyy numbers only exist for LCAD purposes, and the numbers are not allocated until somebody goes to the trouble of authoring the part - so the "Master list" is, in effect, the current PARTS.LST file in your (...) (24 years ago, 5-Mar-01, to lugnet.cad.dev)
|
| |
| | Re: Part numbers master list ?
|
|
(...) Understood. (...) Is the defacto set of Pyy numbers publicly visible on a web site anywhere ? What is the procedure for assigning a Pyy number when I come across a decorated part that I do not see listed (in any list I can find that is). To (...) (24 years ago, 5-Mar-01, to lugnet.cad.dev)
|
| |
| | Re: Part numbers master list ?
|
|
(...) I (...) and (...) (xxxxPyy) (...) As has been mentioned several times in the group, the Pyy numbers are not part of the official TLC nomenclature and are allocated within this LCAD community. Numbers are not intended to be consecutive from 01 (...) (24 years ago, 5-Mar-01, to lugnet.cad.dev)
|
| |
| | Re: Part numbers master list ?
|
|
(...) Gads I hope so. After reading your post I checked out the peeron.com part list and noticed that the cat has part number "x91". I don't know if that's supposed to be 2546x91, or just x91. It's also possible--in fact likely--that the x numbers (...) (24 years ago, 5-Mar-01, to lugnet.cad.dev)
|
| |
| | Part numbers master list ?
|
|
Has anyone taken on the task of building a master list of part numbers ? I've found several lists so far (dan boger's at peeron.com, lutz uhlmann's, lugnet partsref, etc). Each of these contains a large overlap, but none is complete (or as complete (...) (24 years ago, 5-Mar-01, to lugnet.cad.dev)
|
| |
| | Re: Overlapping linetypes?
|
|
(...) Excellent. Thanks for clearing that up! Dave! (24 years ago, 2-Mar-01, to lugnet.cad.dev)
|
| |
| | Re: Overlapping linetypes?
|
|
(...) As long as the overlapping areas are coplanar and use the same color, this approach is valid. I frequently use this approach to draw rings, when there isn't a single ring primitive which fits my needs. Steve (24 years ago, 2-Mar-01, to lugnet.cad.dev)
|
| |
| | Re: Edger utility available
|
|
Wouldn't you know it--there was a minor bug in the code. The edger in its first version would sometimes lock up when checking for overlapping lines in certain cases. I've updated it again to get rid of that bug, so now it's on version 0.6. (URL) you (...) (24 years ago, 2-Mar-01, to lugnet.cad.dev)
|
