Subject:
|
Re: Suggestion for new meta command & help request
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Mon, 24 Apr 2000 13:19:04 GMT
|
Viewed:
|
690 times
|
| |
|
|
"Michael Lachmann" <michael.lachmann@maxmobil.at> writes:
> I need help to understand what this rotation point is all about.
I learned all I needed to know about this from the
comp.graphics.algorithms FAQ. Try to grab it, the subject is well
covered there.
Fredrik
|
|
Message is in Reply To:
 | | Re: Suggestion for new meta command & help request
|
| (...) I believe the problem is not the rotation point itself if the center for rotations is set to a stud or between two studs every thing would work fine, since the default step width of MLCad is halve a stud. So after rotating you can place it (...) (25 years ago, 24-Apr-00, to lugnet.cad.dev)
|
8 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
