 | | Re: part 2951, some questions [DAT]
|
|
(...) I will centre between the lower pegholes then. (...) Goood:) (...) correction: I will not put the measurements up, as they are changing as I get along. Look below for more on this. (...) As of now, it looks like the worst part is figuring out (...) (25 years ago, 5-Jan-00, to lugnet.cad.dev)
|
| |
| | Re: Update 9906
|
|
(...) I got the fixes. Thanks for the rapid turn-around, Chris! About 973s01 - I don't remember if this subfile ever had a back surface. The name does clearly state that there's no back: "~Subpart Minifig Torso without Front or Back". IIRC, the back (...) (25 years ago, 5-Jan-00, to lugnet.cad.dev)
|
| |
| | Re: Update 9906
|
|
(...) Looks like both John and I mistakenly assumed that s\973s01.dat is the torso missing the front surface - in fact it is missing the back as well to cater for those rare torsos with decoration on the back. I sent a corrected version of 973p34 to (...) (25 years ago, 4-Jan-00, to lugnet.cad.dev)
|
| |
| | Re: part 2951, some questions
|
|
(...) I'd say that's a good place to put the origin. On the other hand, the user is fairly likeliy to tilt the bucket off an axle in either the upper or the lower pegholes, so centering the part in the centre of either the upper or lower pegholes (...) (25 years ago, 4-Jan-00, to lugnet.cad.dev)
|
| |
| | Update 9906 [DAT]
|
|
Hi, I was looking at the new parts and discovered that 2 torsos (973p34 and 973p101) are missing some faces from the back. It's not a big deal but it should be fixed on the next update. Also, 4522 (Minifig Tool Mallet) has some blue faces: 1 1 0 0 (...) (25 years ago, 4-Jan-00, to lugnet.cad.dev)
|
