 | | Re: DAT voting page up —Roy Earls
|
| | | Steve Bliss wrote in message <36d579c3.1627208@lu...et.com>... (...) The point here would be that line drawings would not be accurate since the part numbers I've seen are raised and moulded as are the lot numbers and some even have copyrights (...) (26 years ago, 25-Feb-99, to lugnet.cad.dev)
|
| | | |
| | | | | Re: DAT voting page up —Steve Bliss
|
| | | | (...) It's not *that* hard to go from the line drawings to raised forms. Especially since each numeral only needs to be done once. That LEGO logo and copyright notice, now. Those are a whole different level of challenge. Steve (26 years ago, 25-Feb-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: DAT voting page up —Roy Earls
|
| | | | Steve Bliss wrote in message <36d5afa3.15421162@l...et.com>... (...) Okay, I see that I was shooting for a kill and all I got was a dent. My point was to be made by what I'm calling the lot number, it may be the position number of the part on the (...) (26 years ago, 25-Feb-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: DAT voting page up —Bram Lambrecht
|
| | | | (...) the (...) much (...) If you added the numbers on the bottom of the pieces (which even appear in different sizes and different spots on the piece depending on the age) you would have to model the indentation under each "solid" stud too. Can you (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: DAT voting page up —Roy Earls
|
| | | | | Bram Lambrecht wrote in message (...) Hear, hear. Or is it here, here. Shrug..... Roy (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| | | | | |
| | | | | | Re: DAT voting page up —Steve Bliss
|
| | | | (...) Hmm. We'd just make a new primitive, including the stud, the indent beneath the stud, and the ndis's around them (maybe the entire 10x10LDU surface). 1 16 0 4 0 4 0 0 0 0 0 0 0 4 4-4edge.dat 1 16 0 0 0 4 0 0 0 0 0 0 0 4 4-4edge.dat 1 16 0 0 0 (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| | | | |
