Subject:
|
Re: fixes??
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Sun, 30 May 1999 16:19:25 GMT
|
Reply-To:
|
mookie@SPAMCAKEinnocent.com
|
Viewed:
|
696 times
|
| |
|
|
Mookie wrote:
>
> Chris Dee wrote:
> >
> > In lugnet.cad.dev, Tamyra Teed ("Mookie") writes:
> > > Is it possible for someone to fix the stud.dat primitives so there
> > > aren't holes in the tops of the studs in the detail lines? Or is this
> > > only the way every brick and plate draws on my system? it seems there is
> > > always a hole in the detail line upper lefthand side.. from about 9:00
> > > to about 11:00 and from 7:00 to 9:00 is very thin.. I'd do it if I knew
> > > how.. alas I don't :( and I'm not good enough in math anymore to figure
> > > it out... the joys of if you don't use it, you'll lose it :(
> > >
> > > Thanks! And all you part authors keep up the great work!!! it's
> > > appreciated!!!
> > >
> > > Tamy
> >
> > I'm not sure this is a problem with the primitives themselves - more an issue
> > with the renderer? When you view from above at high magnification, do you get
> > the complete circle? If so, this should prove that all the lines are defined in
> > the primitive.
> >
> > Chris
>
> No, I don't get the full circle at any resolution, there is always the
> missing section from about 7:00 to 11:00. I'm viewing these in ldlite,
> though I believe I've seen this before in ldraw and ledit..
> I'll take another look though just to be sure.
> Tamy
Ok, I checked this a little better now, it's only in LDLite that I'm
missing lines on the studs.. Ldraw a little, though the part that's
missing in ldraw is opposite, so I'm guessing it's more the renderer
like you mentioned. is there something we can do with ldlite to get it
to draw the lines a little better? Or should I just "deal" with it? :)
Tamy
|
|
Message has 1 Reply:
 | | Re: fixes??
|
| (...) The problem is the primitive stud*.dat files are specifying two different colors for the same voxel (3D pixel)--the voxels are the edges are being filled with both the edge color and the surface color. So the renderer has to 'decide' which (...) (25 years ago, 1-Jun-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: fixes??
|
| (...) No, I don't get the full circle at any resolution, there is always the missing section from about 7:00 to 11:00. I'm viewing these in ldlite, though I believe I've seen this before in ldraw and ledit.. I'll take another look though just to be (...) (25 years ago, 30-May-99, to lugnet.cad.dev)
|
10 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
