Subject:
|
Re: fixes??
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Sun, 30 May 1999 15:04:56 GMT
|
Reply-To:
|
mookie@innocent.SPAMLESScom
|
Viewed:
|
683 times
|
| |
|
|
Chris Dee wrote:
>
> In lugnet.cad.dev, Tamyra Teed ("Mookie") writes:
> > Is it possible for someone to fix the stud.dat primitives so there
> > aren't holes in the tops of the studs in the detail lines? Or is this
> > only the way every brick and plate draws on my system? it seems there is
> > always a hole in the detail line upper lefthand side.. from about 9:00
> > to about 11:00 and from 7:00 to 9:00 is very thin.. I'd do it if I knew
> > how.. alas I don't :( and I'm not good enough in math anymore to figure
> > it out... the joys of if you don't use it, you'll lose it :(
> >
> > Thanks! And all you part authors keep up the great work!!! it's
> > appreciated!!!
> >
> > Tamy
>
> I'm not sure this is a problem with the primitives themselves - more an issue
> with the renderer? When you view from above at high magnification, do you get
> the complete circle? If so, this should prove that all the lines are defined in
> the primitive.
>
> Chris
No, I don't get the full circle at any resolution, there is always the
missing section from about 7:00 to 11:00. I'm viewing these in ldlite,
though I believe I've seen this before in ldraw and ledit..
I'll take another look though just to be sure.
Tamy
|
|
Message has 1 Reply:
 | | Re: fixes??
|
| (...) Ok, I checked this a little better now, it's only in LDLite that I'm missing lines on the studs.. Ldraw a little, though the part that's missing in ldraw is opposite, so I'm guessing it's more the renderer like you mentioned. is there (...) (25 years ago, 30-May-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: fixes??
|
| (...) I'm not sure this is a problem with the primitives themselves - more an issue with the renderer? When you view from above at high magnification, do you get the complete circle? If so, this should prove that all the lines are defined in the (...) (25 years ago, 30-May-99, to lugnet.cad.dev)
|
10 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
