Subject:
|
fixes??
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Sat, 29 May 1999 23:50:30 GMT
|
Reply-To:
|
mookie@innocent.SAYNOTOSPAMcom
|
Viewed:
|
652 times
|
| |
|
|
Is it possible for someone to fix the stud.dat primitives so there
aren't holes in the tops of the studs in the detail lines? Or is this
only the way every brick and plate draws on my system? it seems there is
always a hole in the detail line upper lefthand side.. from about 9:00
to about 11:00 and from 7:00 to 9:00 is very thin.. I'd do it if I knew
how.. alas I don't :( and I'm not good enough in math anymore to figure
it out... the joys of if you don't use it, you'll lose it :(
Thanks! And all you part authors keep up the great work!!! it's
appreciated!!!
Tamy
|
|
Message has 1 Reply:
 | | Re: fixes??
|
| (...) I'm not sure this is a problem with the primitives themselves - more an issue with the renderer? When you view from above at high magnification, do you get the complete circle? If so, this should prove that all the lines are defined in the (...) (25 years ago, 30-May-99, to lugnet.cad.dev)
|
10 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
