Subject:
|
Re: Cone primitives
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 11 May 1999 17:24:41 GMT
|
Viewed:
|
636 times
|
| |
|
|
In lugnet.cad.dev, John VanZwieten writes:
> I just realized the 1-4con3.dat and 1-4con4.dat don't have optional lines in
> them. Is there a reason for this, or is it just an oversight?
>
> -John Van
Just out of curiosity, what are 'optional lines'?
Jeff
|
|
Message has 1 Reply:
 | | Re: Cone primitives
|
| Optional lines should actually be called "conditional lines." They are used to model rounded surfaces so that the edge-lines only appear if they form the outer boundary of the rounded surface. If you think of a cylinder, you want edge-lines to show (...) (26 years ago, 11-May-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Cone primitives
|
| I just realized the 1-4con3.dat and 1-4con4.dat don't have optional lines in them. Is there a reason for this, or is it just an oversight? -John Van (26 years ago, 10-May-99, to lugnet.cad.dev)
|
13 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
