 | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
|
| with the pin long with stop bush: none of the other technic pins fit into a beam either... i think it is something wrong with the positioning of the primitives (26 years ago, 10-Apr-99, to lugnet.cad.dev)
| | | | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
|
| (...) of (...) Huh? the pins fit just fine. However, you left a ring around the middle of your part which would never allow a technic beam to pass over it. (As insticking the pin through two technic beams at once) --Bram Bram Lambrecht / o o \ (...) (26 years ago, 11-Apr-99, to lugnet.cad.dev)
| | | | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
|
| (...) Jonathan, whether you understand what the complaints are about or not, just take it on faith that this part is _wrong_. As someone else said, if you would get this piece and actually look at it, you would clearly see the flaws. Right now, (...) (26 years ago, 12-Apr-99, to lugnet.cad.dev)
| | | | | Re: part: brick 1 x 2 w/ pattern, technic pin long w/ bush
|
| (...) Do you mean they're of-center in the hole? If so, change the movement rate from "Normal" to "Fine" (by pressing "m", I believe). Then the piece will move 1 LDU, and you can center it in the hole. Jeff (26 years ago, 13-Apr-99, to lugnet.cad.dev)
| |
