To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.devOpen lugnet.cad.dev in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / 11118
11117  |  11119
Subject: 
Re: Announcing LSculpt 0.5.0
Newsgroups: 
lugnet.cad.dev
Date: 
Fri, 1 Oct 2010 03:11:11 GMT
Viewed: 
23654 times
  
In lugnet.cad.dev, Philippe Hurbain wrote:

  
  • DAVID laser scanner to build your own meshes. The free version is perfectly usable (but you’ll need Meshlab to assemble the scans in a single mesh). A webcam and a focusable line laser (I got mine for a few bucks from dealextreme) are all you need to buy to use it.

On a side note, I have to say that this “DAVID laser scanner” sounds incredibly cool to me, so much so that I may need to look into acquiring it.

Additionally, just five short years ago a 3-D scanner setup was apparently a near pipe-dream, hard to come by even for people/entities with considerable resources.

Check out this thread from a little while back: http://news.lugnet.com/cad/?n=12546

What a difference half a decade makes!



Message is in Reply To:
  Re: Announcing LSculpt 0.5.0
 
(...) Excellent! To the palette of tools you mention on LSculpt webpage, I'd like to add (URL) DAVID laser scanner> to build your own meshes. The free version is perfectly usable (but you'll need Meshlab to assemble the scans in a single mesh). A (...) (14 years ago, 29-Sep-10, to lugnet.cad.dev, FTX)

5 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR