 | | Re: Can LDGLite print the current orientation matrix? (feature request)
|
|
(...) Ok the current copy of main.c in CVS has a function that does part A. I have most of part B working, but I don't completely understand the STEREO stuff in the location part of an l3p camera setting. Can you or somebody explain it? I can create (...) (23 years ago, 8-Jan-02, to lugnet.cad.dev)
|
| |
| | Re: Proposal: New Parts Category for round parts
|
|
(...) The term "liftarm" is the official Lego US Consumer Affairs name. It is derived from the official Danish part name. The term has been used widely in Lego advertising, particularly in the names of supplemental or parts packs, particularly in (...) (23 years ago, 8-Jan-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Proposal: New Parts Category for round parts
|
|
(...) It sounds like a good idea, although it fails the "is a" test. That is, if I look at a piece in my hand, I might think "It is a brick" "It is a slope" "It is a hinge" "It is a plate". I would not is "It is a round" I think the previous (...) (23 years ago, 7-Jan-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Proposal: New Parts Category for round parts
|
|
(...) I'd have no hassle calling them bricks, but they need to be called "brick with holes" or "brick, technic" or "technic brick" to distinguish them from hole-less bricks. Should it be a separate category? I lean towards yes, because there's quite (...) (23 years ago, 7-Jan-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Proposal: New Parts Category for round parts
|
|
(...) Thank you for bringing this to my attention. In the cause of accurate part identification, part 3836 is being renamed to Brick 3/4 x 1 & 1/2 x 1/2 Corrugated with Bar 4L at 30 Degree Angle ;) Steve (23 years ago, 7-Jan-02, to lugnet.cad.dev.org.ldraw, lugnet.off-topic.fun)
|
