| | Re: [Parts] Plate 1x1 Round with Towball
|
|
(...) Again, confusion (<g>): The question on the table is whether the BALL has a hole in it, NOT the stud... (All of mine have always had a hole through the stud). Of course, you did write "hole in the tow ball" earlier, so I'm presuming that this (...) (26 years ago, 10-Mar-99, to lugnet.cad.dev)
|
|
| | Re: [Parts] Plate 1x1 Round with Towball
|
|
(...) No. I am very distinctly talking about the older item. I'm not sure what the new item you are talking about, but both of the elements that I described were in my collection years before Dk Grey became available, and both have a ball and a (...) (26 years ago, 10-Mar-99, to lugnet.cad.dev)
|
|
| | Re: Technic Axles - go rounded?
|
|
(...) I've actually run into a problem once with the axle being too long. I was trying to model a craft that I built, and I ended up fudging the virtual model by pushing the axle into the motor, because otherwise it popped through the radar dish on (...) (26 years ago, 10-Mar-99, to lugnet.cad.dev)
|
|
| | Re: [Parts] Plate 1x1 Round with Towball
|
|
(...) There's one hole through the stud and the base where it is placed. Leonardo (26 years ago, 10-Mar-99, to lugnet.cad.dev)
|
|
| | Re: Part Numbering Crisis in LDraw
|
|
(...) True. As the best way to keep everyone at least somewhat happy. (...) I don't want to over-use 3-digit numbers. Only where necessary and unavoidable. For instance; The complete yellow dinghy does have the correct number. So we can make a (...) (26 years ago, 9-Mar-99, to lugnet.cad.dev)
|