 | | Re: 2867.dat Curved 9V Track - reddy
|
|
(...) I think it is incomplete. If I understand your suggustion correctly, that would only work in one curve direction, left or (exclusive or) right. Also, the curved single-rails 3229a, 3229b, and 3230a are not aligned that way. I think a better (...) (23 years ago, 19-Apr-03, to lugnet.cad.dat.parts)
|
| |
| | Re: 2867.dat Curved 9V Track - reddy
|
|
(...) That's your right ! (...) The center of the track circle is at: Z=800 (...) O.K. i check it out. When reddy, i'll notify you, and can send you the file for checking - so that i don't upload it too many times on LUGNET. (...) (23 years ago, 19-Apr-03, to lugnet.cad.dat.parts)
|
| |
| | Re: 2867.dat Curved 9V Track - reddy
|
|
(...) Very nice! Good work on this. :) However (I always seem to have a 'however' ;), I'm not sure about your choice of the zero-point and the orientation of the part. The point you chose was very logical, but it might not be practical. In relation (...) (23 years ago, 19-Apr-03, to lugnet.cad.dat.parts)
|
| |
| | Re: 9V Curved Track
|
|
(...) The information i have abouth parts center comes from the LDRAW FAQ - Question24 Steve Bliss writes : Quote Tip#1: The Ldraw standard for positioning is to the center of the piece on X=0 and Z=0. Usually, the top of the part (excluding studs) (...) (23 years ago, 17-Apr-03, to lugnet.cad.dat.parts)
|
| |
| | Re: 2867.dat Curved 9V Track - ready
|
|
(...) <SNIP> (...) Perhaps not for you, but without this little piece of software wouldn't i be able to create this part. It was just THIS that make me believe that i could create this part. I'm not a mathematic gouru, and trust me, i'm going to (...) (23 years ago, 17-Apr-03, to lugnet.cad.dat.parts)
|
