Subject:
|
Re: Subpart thingy.
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sat, 27 Oct 2001 09:33:43 GMT
|
Viewed:
|
1792 times
|
| |
|
|
In lugnet.cad.dat.parts, Lars C. Hassing writes:
> If you look at it from the bottom you can see that the T-surface
> is divided into two by an edge-line (Zoom 3000%):
> http://home16.inet.tele.dk/hassing/xtraedge.gif
>
> The always hidden surface is seen here:
> http://home16.inet.tele.dk/hassing/xtrasurf.gif
> If the subpart is made out of quads (and not boxes)
> you can split the long surface into two quads.
> /Lars
The extra line IS present in the 30504 piece, at least the one that I had, as
well as several other peices. It is just very faint. As for the hidden surface,
I wouldn't worry too much about it unless it were to crash your system or slow
down rendering time.
|
|
Message is in Reply To:
 | | Re: Subpart thingy.
|
| If you look at it from the bottom you can see that the T-surface is divided into two by an edge-line (Zoom 3000%): (URL) always hidden surface is seen here: (URL) the subpart is made out of quads (and not boxes) you can split the long surface into (...) (23 years ago, 26-Oct-01, to lugnet.cad.dat.parts)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
