Subject:
|
Re: Subpart thingy.
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 25 Oct 2001 02:25:38 GMT
|
Viewed:
|
1394 times
|
| |
|
|
>
> I'm afraid you'll have to make the subpart (primitive?) from scratch.
> The shortcut suggested above has an undesirable edge line
> (and also an always hidden surface).
> /Lars
What program are you using to view the part? I looked at it in l3lab and it
looked fine. There is not supposed to be a top surface on the part.
|
|
Message has 1 Reply:
 | | Re: Subpart thingy.
|
| (...) Great program, huh? I use it too :-) If you look at it from the bottom you can see that the T-surface is divided into two by an edge-line (Zoom 3000%): (URL) always hidden surface is seen here: (URL) the subpart is made out of quads (and not (...) (23 years ago, 25-Oct-01, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Subpart thingy.
|
| (...) I'm afraid you'll have to make the subpart (primitive?) from scratch. The shortcut suggested above has an undesirable edge line (and also an always hidden surface). /Lars (23 years ago, 24-Oct-01, to lugnet.cad.dat.parts)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
