 | | Re: Question about generating curves
|
|
(Note: Please follow-up to ".cad.dev".) (...) OK, first you need to bear in mind that LDraw does _NOT_ draw true curves, it draws _angles_. If you have enough angles in a line, from a sufficient distance, this angled line will _appear_ to be a true (...) (24 years ago, 10-Jan-01, to lugnet.cad.dat.parts, lugnet.cad.dev)
|
| |
| | Re: Question about generating curves
|
|
----- Original Message ----- From: "Franklin W. Cain" <fwcain@yahoo.com> To: <lugnet.cad.dat.part...gnet.com>; <lugnet.cad.dev@lugnet.com> Sent: Tuesday, January 09, 2001 9:38 PM Subject: Re: Question about generating curves (...) Back faces are (...) (24 years ago, 10-Jan-01, to lugnet.cad.dev)
|
| |
| | Re: Question about generating curves
|
|
In lugnet.cad.dat.parts, Franklin W. Cain writes: <snip> (...) <snip> (...) Franklin, Your quite a humorus man. What the hell did you just say! Please allow me to explain why I'm laughing. I didn't graduate high school, I don't have a GED but even (...) (24 years ago, 10-Jan-01, to lugnet.cad.dev)
|
| |
| | Re: Question about generating curves
|
|
"Joseph Cardana" <jcardanas@home.com> wrote in message news:G6xJvM.JIv@lugnet.com... (...) allow (...) have (...) to (...) the (...) Conditional lines are used to show the outer boundary of a curved _surface_. Consider a cylinder. Between each quad (...) (24 years ago, 10-Jan-01, to lugnet.cad.dev)
|
| |
| | Re: Question about generating curves
|
|
Thanks everyone for your helpful information. I believe that I can now properly model curves manually (as opposed to just using cylinder primitives). I'll be trying it out on the "coarse" version of the Duplo bottom stud. As for BFC statements, I (...) (24 years ago, 10-Jan-01, to lugnet.cad.dev)
|
| |
| | Re: Question about generating curves
|
|
I could make a tool to display a part (wireframe view) from any angle. Clicking on a polygon command in the DAT source (displayed below the view pane) would cause the edges of that polygon to appear as arrows, showing the order they were defined in. (...) (24 years ago, 10-Jan-01, to lugnet.cad.dev)
|
| |
| | Re: Question about generating curves
|
|
(...) To check the BFC'ness of your file, use L3Lab. While viewing the file, select the Test | mytest6 menu option. This will color-code all the rendered surfaces. Green is the front/outside of correctly wound surfaces, Red is the back/inside, and (...) (24 years ago, 10-Jan-01, to lugnet.cad.dev)
|
