Subject:
|
Re: [Part] 3836.dat - Minifig Tool Broom
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Mon, 19 Jun 2000 17:29:00 GMT
|
Viewed:
|
2845 times
|
| |
|
|
In lugnet.cad.dat.parts, Imre Papp wrote:
> Dear part authors,
>
> I attach the '3836.dat - Minifig Tool Broom' part for review and comments.
>
> Questions and requests for comment:
>
> 1. Is the naming acceptable?
How about Minifig Tool Pushbroom? There is at least one other broom part
out there, so we might as well be specific now.
> 2. Do the default placement and the orientation of the part fit the convention used for minifig tools? (Actually I placed broom
> upright. Alternative orientation could be the 'sweeping position' i.e. by turning 155 degrees around X axis, as a clever minifig
> would use it to clean the floor.)
I think the vertical positioning is best, to make it easy to place the
broom into a minifig hand. But I would rotate the broom 180 degrees around
X, and lower it so the top of the part is at Y=0.
Steve
|
|
Message is in Reply To:
 | | [Part] 3836.dat - Minifig Tool Broom [DAT]
|
| Dear part authors, I attach the '3836.dat - Minifig Tool Broom' part for review and comments. Questions and requests for comment: 1. Is the naming acceptable? 2. Do the default placement and the orientation of the part fit the convention used for (...) (26 years ago, 19-Jun-00, to lugnet.cad.dat.parts)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
