 | | Re: Slope Brick 1x1
|
|
(...) LEGO name on Factory Pick-a-Brick is "Roof Tile 1 X 1 X 2/3" Philo (16 years ago, 1-Oct-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Slope Brick 1x1
|
|
(...) I agree. So both LDraw and Peeron should change the name. I see that the name has been changed allready on the partstracker of both part 50746 and 54200. What is the official LEGO name for the part or doesn't LEGO name it's parts anyway? Do (...) (16 years ago, 1-Oct-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Slope Brick 1x1
|
|
(...) With the notable exception of the 45 degree slopes, none of the other slope parts have exactly the inclination used in the part description. Note that all have a small vertical section (or step) at the front which causes the angle to deviate (...) (16 years ago, 30-Sep-08, to lugnet.cad.dat.parts)
|
| |
| | 61409 - Slope Brick 18 2 x 1 x 2/3 Grille [DAT]
|
|
Hi all, Just whipped up this mockup for 61409 and thought I'd share it. I don't currently have the part handy and I wasn't sure if the little bump in the middle should be explicitly modelled but it serves as a pretty useful mockup for most models. (...) (16 years ago, 5-Sep-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Help with Patterns
|
|
(...) Unfortunately, I don't think that T-junctions can be made visible in MLCad, since I don't think it has a wireframe mode. However, if you use LDraw Design Pad with LDView in polling mode, you can set LDView to wireframe, and the T-junctions (...) (16 years ago, 27-Aug-08, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: Help with Patterns
|
|
(...) etc. (...) I was wondering if you upload a more concrete example using a lego editing tool and show what the difference would look like between the three examples using one of them - it would be helpful to me to be able to see something that (...) (16 years ago, 27-Aug-08, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: Help with Patterns
|
|
(...) you put the two images from my post into LDraw's gallery, and send me links to them, I'll add a page to ldraw.org. --Travis (16 years ago, 26-Aug-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Help with Patterns
|
|
(...) It's the same thing. Actually, it's worse -- rect.dat has edge-lines. So it can't be used in place of a quad. Generally, avoiding t-junctions is harder when working with primitives - you have to know where the outside vertices are on the (...) (16 years ago, 26-Aug-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Help with Patterns
|
|
(...) [SNIP-SNAP] Travis, this is a fine explanation! How about uploading a more formal version to the tutorial page (URL) or the specs (URL) (16 years ago, 26-Aug-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Help with Patterns
|
|
(...) That's supposed to say that the bottom version is made up of 4 quads. --Travis (16 years ago, 26-Aug-08, to lugnet.cad.dat.parts, FTX)
|
