 | | 47457 2 x 2 x 2/3 Two Top Studs, Curved Slope End [DAT]
|
|
What approach should I take to create the "Curved Slope End". Should I create a curved and slope line and surface primitive? The basis for this part file (version 2) is 41855 2 x 2 x 2/3 Slope Rounded. In the uploaded 47457v2.dat file, you'll see (...) (20 years ago, 10-Sep-04, to lugnet.cad.dat.parts)
|
| |
| | Bow-tie quads in BFC-certified parts
|
|
(Note that I'm sending followups to the lugnet.cad.dev.org.ldraw newsgroup alone, because that seems to be the appropriate group, but I think the audience of the lugnet.cad.dat.parts group should see this.) In the process of testing my next major (...) (20 years ago, 10-Sep-04, to lugnet.cad.dev.org.ldraw, lugnet.cad.dat.parts, FTX)
|
| |
| | Re: Click-Rotation Parts
|
|
(...) Ah, I see! I'm observing a Knight at the moment. 48171 and 48170 represent the two ways that the cup-shaped cogged sub-part is rotated. Shoulder and hip joints are the same as 48170. Elbow and knees are like 48171. The one slightly different (...) (20 years ago, 9-Sep-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Click-Rotation Parts
|
|
(...) The cogs weren't the problem. The problem ist the junction between the primitive and the part. Where does the primitive end and where does the part begins? Not every part has the same junction to the primitive. For example: The rotation-offset (...) (20 years ago, 9-Sep-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Click-Rotation Parts
|
|
(...) Huummm, I'll see if my Lego Camera can do some justice to the click-rotation parts. Otherwise, I'm going to have to wait till I can get back to the Portland State University Media Lab. I'm looking into the part at 10x and the wavy cogs on (...) (20 years ago, 9-Sep-04, to lugnet.cad.dat.parts)
|
