 | | 2736 (Technic Axle Towball) [DAT]
|
|
I'm not sure if this is the proper procedure, but I noticed a problem in part 2736 (Technic Axle Towball) which appears to have been caused by the part being authored without rotating the viewpoint away from the standard one. The cylinder which was (...) (24 years ago, 13-Sep-00, to lugnet.cad.dat.parts)
|
| |
| | Re: Skeleton Torso: Attn Steve Bliss
|
|
(...) Steve, I have shortened the shoulder-pegs as you suggested. Then, just for fun, I put a transparent skull on top a transparent torso and ran it through POV. The neck peg sticks up into the skull, ruining the effect. :) Dennis. (24 years ago, 12-Sep-00, to lugnet.cad.dat.parts)
|
| |
| | Re: Skeleton Torso: Attn Steve Bliss
|
|
[follow-up re-directed to ".dev"] (...) I'd like to take a crack at it. Thanks, Franklin (24 years ago, 12-Sep-00, to lugnet.cad.dat.parts)
|
| |
| | Re: Skeleton Torso: Attn Steve Bliss
|
|
(...) Travis Cobbs created the lines for the cylinders. To be honest, it was over my head. But I will study the explaination he gave and will try to shorten the cylinders. (...) Yes. And I had to edit 99% of my quad lines for 'bad vertex sequence'. (...) (24 years ago, 12-Sep-00, to lugnet.cad.dat.parts)
|
| |
| | Re: Skeleton Torso: Attn Steve Bliss
|
|
(...) Just glancing at it (in L3Lab (the spine looks particularly cool in transparent/non-dithered mode)), the only thing that leaps out is the cylinders that make the base of the shoulder-pegs should be shorter -- they intrude into the balls on the (...) (24 years ago, 11-Sep-00, to lugnet.cad.dat.parts)
|
