Subject:
|
Re: Overlapping quads/triangles for patterns
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 26 Apr 2002 21:37:21 GMT
|
Viewed:
|
541 times
|
| |
|
|
> When making patterned parts, it is allowable to overlap regions
> of the same colour, but you should not overlap regions of different
> colours.
Niels,
While I wouldn't consider this grounds for "hold"-ing the pattern,
other reviewers might (and have done so...). So, I would discourage this.
Instead, try to find the "best" (or easiest) mid-point(s) to use,
and prevent the overlaps.
Hope this helps! ;-)
Franklin
|
|
Message has 1 Reply:
 | | Re: Overlapping quads/triangles for patterns
|
| (...) I'll add my 2 cents as the author of LDView. This won't usually cause any visual problems, but it can. If you enable specular in LDView, it's possible for the shininess to be different on the two, resulting in noise where they overlap. It's (...) (23 years ago, 28-Apr-02, to lugnet.cad)
|
Message is in Reply To:
10 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
