Subject:
|
How wide is the neck-mark?
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sat, 23 Dec 2000 23:36:54 GMT
|
Viewed:
|
1961 times
|
| |
|
|
In lugnet.cad, Chris Dee writes:
>
> I have commented the neck mark area out of s\973s01.dat -
> actually it is only a 1/4 cylinder.
> 0 Uncomment for neck mark
> 0 1 16 0 -4 0 4.243 0 -4.243 0 -8 0 -4.243 0 -4.243 1-4cyli.dat
Hey, Chris, are you certain about this?
The revised subfile that I copied from a previous message
on this thread has a *half*-cylinder hole
for the neck-mark, not just a *quarter*-cylinder.
Because the gap in the subfile that I copied is a half-cylinder,
I've been using a half-cylinder for the neck-marks of the torso
DAT files I've sent to Steve and posted here.
Thanks,
Franklin
|
|
Message has 1 Reply:
 | | Re: How wide is the neck-mark? [DAT]
|
| (...) I am certain that this is the way I have modified the primitive and submitted to Steve. I have modified all the existing torsos to match, and submitted those also. True, the existing prmitive does use 1 24 0 -4 0 6 0 0 0 -8 0 0 0 -6 (...) (24 years ago, 27-Dec-00, to lugnet.cad)
|
Message is in Reply To:
| | Re: [part] Updated S\973S01.DAT
|
| (...) do (...) I have commented the neck mark area out of s\973s01.dat - actually it is only a 1/4 cylinder. 0 Uncomment for neck mark 0 1 16 0 -4 0 4.243 0 -4.243 0 -8 0 -4.243 0 -4.243 1-4cyli.dat and will today be sending the amended subpart and (...) (24 years ago, 5-Nov-00, to lugnet.cad)
|
13 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
