Special:
|
[DAT] (requires LDraw-compatible viewer)
|
Subject:
|
Re: Beveled flex tubing
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 24 May 2011 17:35:52 GMT
|
Viewed:
|
20549 times
|
| |
|
|
> That did it! Here's the part I needed... thanks again!!!!
Great!
Note that it may be easier to use slant instead of stretch/rotate. It is a bit
more difficult to figure out at the beginning, but it avoids calculations and
gives simpler coefficients.
Here is the result, applied to your file:
0 ~Technic Flex-System Hose 45 bevel End
0 Name: 76_bevel3.dat
0 Author: Lar with hints from Philo
0 WRITE Inner cylinder (unbeveled part to bring inner bevel to same endpoint )
0 ROTATION CENTER 0 0 0 1 "Custom"
0 ROTATION CONFIG 0 0
1 16 0 0 0 2 0 0 0 2 0 0 0 2 4-4cyli.dat
0 STEP
0 WRITE Inner and outer bevels
1 16 0 0 0 -4 0 0 0 4 0 0 0 -4 4-4cyls.dat
1 16 0 2 0 -2 0 0 0 2 0 0 0 -2 4-4cyls.dat
0 STEP
0 WRITE Face ring, slanted 100%
1 16 0 4 0 2 0 0 2 1 0 0 0 2 4-4ring1.dat
0 STEP
0 WRITE Edge lines for face ring, slanted 100%
1 16 0 4 0 2 0 0 2 1 0 0 0 2 4-4edge.dat
1 16 0 4 0 4 0 0 4 1 0 0 0 4 4-4edge.dat
0
|
|
Message is in Reply To:
 | | Re: Beveled flex tubing [DAT]
|
| (...) That did it! Here's the part I needed... thanks again!!!! 0 ~Technic Flex-System Hose 45 bevel End 0 Name: 76_bevel3.dat 0 Author: Lar with hints from Philo 0 ROTATION CENTER 0 0 0 1 "Custom" 0 ROTATION CONFIG 0 0 0 WRITE Inner cylinder (...) (14 years ago, 24-May-11, to lugnet.cad)
|
9 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
