To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / 1516
  Re: Problem loading LUGNET .dats into LEdit
 
(...) Thomas, open up the offending file and check it for problems. Make sure there are no comment lines that don't begin with a '0'. Make sure all the part lines are entirely on one line each, and not wrapped to the next line. Sometimes that screws (...) (26 years ago, 4-Apr-99, to lugnet.cad)
 
  Re: Problem loading LUGNET .dats into LEdit
 
An example of a model that works is: 0 Name: 18wheelr.dat 0 Author: Bram Lambrecht One that doesn't is Duane Hess' jeep.dat. I looked at both files and noticed some differences: jeep.dat had empty lines throughout the file - I removed those. (...) (26 years ago, 4-Apr-99, to lugnet.cad)
 
  Re: Problem loading LUGNET .dats into LEdit
 
(...) Oh, ok...that's just the name of the first file in my \models directory...I must not have gotten it from lugnet.cad.dat (...) I just re-downloaded this .dat file and it loads/displays properly in LEdit. (...) I loaded the file in LDAO editor. (...) (26 years ago, 4-Apr-99, to lugnet.cad)
 
  Re: Problem loading LUGNET .dats into LEdit
 
(...) Thomas, what is the exact URL of the 18wheelr.dat file you are accessing? The only one that I know of it the one Bram announced in December pointing to his tutorial site at advanced.org, right. And if that URL (URL) loaded up, it displays as a (...) (26 years ago, 4-Apr-99, to lugnet.cad)
 
  Re: Problem loading LUGNET .dats into LEdit
 
(...) Hmm, well, that's good news and bad news then. Good news that it works, but bad news that it's going to be probably impossible to replicate. (...) Steve, is it possible that an older version of LDAO's editor could have become confused by the (...) (26 years ago, 5-Apr-99, to lugnet.cad)
 
  Re: Problem loading LUGNET .dats into LEdit
 
(...) It's possible, but I think (no, strike that; let me check--it will only take a minute). Drat! I scan'n'replace for bare CR's, but not bare LF's. So, yes, LDAO would have a problem with .DAT files where the lines are broken by just LF's, (...) (26 years ago, 5-Apr-99, to lugnet.cad)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR